Maretron

MPower 12 Channel DC Load Module NMEA 2K with 12" Pigtail Adapter Cable for J1 & J2 ConnectorsDesigned for vessels of all sizes with smaller loads, the MPower® CLMD12 is a compact 12-Channel DC Load Controller Module. Two of the 12 breakers handle a...

MPower® 16-Channel DC Load Controller Module with NMEA 2K with J1 & J2 ConnectorsFor larger breakers and more circuits, the MPower® CLMD16 is a 16-Channel DC Load Controller Module. Four of the 16 breakers handle a maximum of 25 amps, and twelve breakers handle...

MPower® 16-Channel DC Load Controller Module with NMEA 2K without ConnectorsFor larger breakers and more circuits, the MPower® CLMD16 is a 16-Channel DC Load Controller Module. Four of the 16 breakers handle a maximum of 25 amps, and twelve breakers handle a maximum of...

MS-1085-N Rectangular Magnetic Switch for OutdoorsApplications: Convenient surface mounting Mounting screws included Specifications: ABS Plastic Enclosure IP67 Hermetically sealed reed switch encapsulated in polyurethane WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to...

Multiport boxes allow several drop cables to be consolidated and connected back to the trunk, which eliminates the need to have numerous tees connected near a single point. Multiport boxes connect back to the trunk through a double-ended cordset and Tee. Ideal for consolidating...

N2KView® Vessel Monitoring and Control SoftwareWhether you are interested in monitoring your vessel's systems while underway or remotely from your home or office, Maretron's N2KView® software displays the information you need including engines, generators, tanks, rudders, navigation instruments, local weather, and much, much more....

Mini Gender ChangersMaretron cables have a male connector on one end and a female connector on the other end. Normally, the male connector points back towards the network power supply, but on some occasions, this gets reversed and a gender changer can be used...

Maretron NM-CF Mini Male to Micro Female ReducerThe reducer is used to change from a Mini cable to Micro or Mid cable. For example, one end of the network might be terminated at the top of the mast but it may not be desireable...

Maretron NM-NM Mini Gender Changer, Male to MaleMaretron cables have a male connector on one end and a female connector on the other end. Normally, the male connector points back towards the network power supply, but on some occasions, this gets reversed and a...

NMEA 0183 10 Meter Connection CableA 10 Meter NMEA 0183 connection cable specifically for Maretron's SSC200 & SSC300 Solid State Compasses. Specifications: Data Interface: NMEA 0183 Box Dimensions: 2"H x 6"W x 7"L WT: 1.8 lbs UPC: 873804002873 Quick Guide (pdf)Owner's Manual (pdf)

Network Bus ExtenderPart #: NBE100-01Maretron's NBE100 (Network Bus Extender) allows you to extend the maximum node count, network trunk length and cumulative drop length of any NMEA 2000 network. The NBE100 solves bus errors and other electrical issues caused by exceeding any of these...

NMEA 2000 Starter Kit 1Maretron's deluxe starter kit provides all the necessary cables and connectors necessary to connect two products together on an NMEA 2000® network.   Contacts are gold-plated brass and couplings are nickel-plated brass for durability and reliability.Included in the Box: (1) 5-Meter...

NMEA 2000 Starter Kit 2 Maretron's deluxe starter kit provides all the necessary cables and connectors necessary to connect two products together on an NMEA 2000® network.   Contacts are gold-plated brass and couplings are nickel-plated brass for durability and reliability.Included in the Box: (1)...

Maretron NMEA 2000 Starter KitBuilding a New NMEA 2000 Network onboard? Save when buying this Maretron NMEA 2000 Starter Kit. Everything you need for a basic NMEA 2000 Bus/Network or to start a complex one. Please see the ACCESSORIES tab above if additional equipment...

Non-Displacement Hull Focus Tube SAE 5-BoltSAE 5-Bolt non-displacement hull focus tube from Maretron.WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

Pressure Transducer - 0 to 5000 PSIThis pressure transducer is designed to connect to the NMEA 2000® network via a Maretron FPM100 Fluid Pressure Module.Specifications: Range: 0 to 5000 PSI (344.74 bar) Accuracy: +/- 0.5% Full Scale Type: Absolute (no vent tube) Installation:All Maretron...

Pressure Transducer 0 to 1.5 PSIFor use with FPM100 Fluid Pressure MonitorWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

Pressure Transducer 0 to 3 PSI - for the FPM100 Fluid Pressure MonitorWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov. Owner's Manual (pdf)

RAA100 NMEA 2000®Rudder Angle AdapterThe RAA100 is used to adapt commercially available resistive rudder angle senders to the NMEA 2000® network. This allows you to observe rudder angle anywhere on the vessel where there is an NMEA 2000® compatible display such as the Maretron...

Remote Key FobMaretron's remote key fob allows you to control and monitor certain features of your vessel remotely, such as powering on/off specific systems or switching between different modes like "Sleep Mode". It typically works in conjunction with a Maretron digital switching system and...

RIM100 Run Indicator ModulePart #: RIM100-01Maretron's Run Indicator Module monitors both AC and DC electrical circuits and reports, over an NMEA 2000 network, whether or not the electrical circuit is energized and running. The RIM100 works equally as well for monitoring manually switched loads...

SAE 5-Bolt Pattern Focus Tube w/Dead Band EliminatorFocus tubes allow the TLM100/TLM150 ultrasonic tank level monitors to be used for level measurement on vessels with non-displacement hulls at up to 15° of pitch or roll, compared to 6° pitch or roll for the sensor...

SIM100 Switch Indicator ModuleMaretron's Switch Indicator Module monitors switch closure devices including, but not limited to, safety equipment (heat, smoke, carbon monoxide, explosive vapor detectors), security systems (motion, vibration, glass break, door and port hole magnetic switches), and vessel monitoring equipment (valve closed/open, high...

Solid-State Rate/Gyro Compass w/10m Cable & ConnectorMaretron's SSC300, implementing the second generation of Maretron's award-wining compass technology, is a solid state, rate gyro electronic compass that provides better than 0.7x heading accuracy through q45x of roll and pitch angle, and better than 1x roll...

Solid-State Rate/Gyro Compass without CablesMaretron's SSC300, implementing the second generation of Maretron's award-wining compass technology, is a solid state, rate gyro electronic compass that provides better than 0.7x heading accuracy through q45x of roll and pitch angle, and better than 1x roll and pitch...

Spare Paddle Wheel KitMaretron spare paddle wheel kitWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

Submersible Pressure Transducer - 0-1.5 PSIThe submersible pressure transducers are used together with Maretron's Fluid Pressure Monitor (FPM100), which allows tank fluid level to be broadcast over an NMEA 2000® network where it can be monitored from any compatible NMEA 2000® display. When used...

Submersible Pressure Transducer 0-3 PSIMaretron’s submersible pressure transducers indicate tank levels and can be installed directly in the tank. Please follow these instructions to mount and connect a submersible pressure transducer to an NMEA 2000® network via a Maretron FPM100 Fluid Pressure Monitor. Maretron...

The TR3K temperature probe is for use with the Maretron TMP100 Temperature Module (optional extra) or the DCM100 DC Monitor (it is included with the DCM100). This probe ends in a ring terminal and can be used to measure battery temperature or any other...

TLA100 NMEA 2000®Tank Level AdapterThe TLA100 is used to adapt commercially available resistive tank senders to the NMEA 2000® network. This allows you to observe tank levels anywhere on the vessel where there is an NMEA 2000® compatible display such as the Maretron DSM200.The...

The TLM100 is used to sense levels of liquid tanks using ultrasonic technology and transmit the liquid levels over the NMEA 2000 network. This allows you to observe tank levels anywhere on the vessel where there is an NMEA 2000 compatible display such as...

The TLM150 is used to sense levels of gasoline tanks using ultrasonic technology and transmit the gasoline levels over the NMEA 2000 network. This allows you to observe gasoline tank levels anywhere on the vessel where there is an NMEA 2000 compatible display such...

Maretron's TMP100 measures the temperature for up to 6 temperature probes and reports the information over an NMEA 2000 network. The TMP100 supports up to 4 thermistor probes and 2 high temperature thermocouple probes. Optional thermistor probes (-20 deg. C to 80 deg. C...

Ultrasonic Wind & Weather AntennaMaretron's outdoor weather station measures wind speed and direction, air temperature, barometric pressure, and relative humidity. The wind measurement is performed using ultrasonic sensors, which means there are no moving parts to wear out or get caught in the rigging.The...

USB100 NMEA 2000® / USB GatewayMaretron's USB100 is a gateway for bridging USB equipment using NMEA 0183 sentences - such as an on-board computer running navigational software - with an NMEA 2000® network. The gateway automatically converts incoming NMEA 2000® messages to NMEA 0183...